Wind turbine steady-state response

Provide feedback, request enhancements, and get help with wind-turbine computer-aided engineering tools.

Moderators: Bonnie.Jonkman, Jason.Jonkman

Jing.Li
Posts: 10
Joined: Thu Aug 29, 2019 2:42 pm
Organization: GE Research
Location: US - New York

Wind turbine steady-state response

Postby Jing.Li » Mon Jul 20, 2020 3:58 pm

Dear Jason,

Below is Figure 9-1 found in the report "Definition of a 5-MW Reference Wind Turbine for Offshore System Development". I would like to generate a similar steady-state response plot for a wind turbine that I'm currently modeling in OpenFAST.

steady_state.png
steady_state.png (91.17 KiB) Viewed 36 times


It was described in the report: "We obtained the steady-state response of the land-based 5-MW baseline wind turbine by running a series of FAST with AeroDyn simulations at a number of given, steady, and uniform wind speeds. The simulations lengths were long enough to ensure that all transient behavior had died out; we then recorded the steady-state output values. ... Start-up transient behavior is an artifact of computational analysis. To mitigate this behavior, we suggest using the steady-state values of the rotor speed and blade-pitch angles found in Figure 9-1 as initial conditions in simulations."

Could you elaborate on how the steady-state values are obtained? After periodic steady state has been established, is it appropriate to use the time average of the time series in the last rotor revolution?

Thank you in advance,
Jing

Jason.Jonkman
Posts: 4933
Joined: Thu Nov 03, 2005 4:38 pm
Location: Boulder, CO
Contact:

Re: Wind turbine steady-state response

Postby Jason.Jonkman » Tue Jul 21, 2020 6:37 am

Dear Jing,

Yes, that is correct.

That said, we are currently working with Envision Energy to add new steady state solver within OpenFAST so that steady state solutions can be solved directly, rather than by running time-domain simulations and waiting for all start-up transients to die out. This new functionality should be publicly released later this fall.

Best regards,
Jason Jonkman, Ph.D.
Senior Engineer | National Wind Technology Center (NWTC)

National Renewable Energy Laboratory (NREL)
15013 Denver West Parkway | Golden, CO 80401
+1 (303) 384 – 7026 | Fax: +1 (303) 384 – 6901
nwtc.nrel.gov


Return to “Computer-Aided Engineering Software Tools”

Who is online

Users browsing this forum: No registered users and 1 guest