airfoilprep.py implementation into simple BEM Code

Discuss acquisition, use, and manipulation of airfoil data.

Moderator: Bonnie.Jonkman

Logan.Unser
Posts: 1
Joined: Fri Jul 10, 2020 2:35 pm
Organization: TN Tech
Location: United States

airfoilprep.py implementation into simple BEM Code

Postby Logan.Unser » Sun Jul 12, 2020 9:57 am

Hello,

I am writing a BEM code implementing the solution algorithm presented in A simple solution method for the blade element momentum equations with guaranteed convergence by A. Ning ( https://doi.org/10.1002/we.1636 ). I am using the airfoilprep.py module to extrapolate the airfoil performance out to +-180 degrees. My question comes down to when to estimate airfoil performance. Do I estimate airfoil performance for each section of the blade, or just one time at the mean radius and chord? In Seligs description of the technique used for airfoilprep.py, it outlines the process, but doesn't describe how to use it in practice. Both seem like reasonable choices, but I am certain that one is accepted practice. Thank you for your guidance in this matter.

Best Regards,


Logan Unser
Tennessee Tech University

Jason.Jonkman
Posts: 4952
Joined: Thu Nov 03, 2005 4:38 pm
Location: Boulder, CO
Contact:

Re: airfoilprep.py implementation into simple BEM Code

Postby Jason.Jonkman » Mon Jul 13, 2020 7:10 am

Dear Logan,

I'm sorry, but I'm not really sure I understand your question or what you mean by "airfoil performance".

Are you asking at what stations along the blade should you apply the 3D rotational augmentation (Du an Selig) model? The 3D rotational augmentation will have the largest effect for inboard airfoils, but may have some non-negligible effect for outboard airfoils.

Best regards,
Jason Jonkman, Ph.D.
Senior Engineer | National Wind Technology Center (NWTC)

National Renewable Energy Laboratory (NREL)
15013 Denver West Parkway | Golden, CO 80401
+1 (303) 384 – 7026 | Fax: +1 (303) 384 – 6901
nwtc.nrel.gov


Return to “Airfoils”

Who is online

Users browsing this forum: No registered users and 0 guests