Load Calculation Tool for OC4 on SIMPACK

Discuss theory and modeling of wind-turbine structures.

Moderator: Bonnie.Jonkman

John.Chang
Posts: 5
Joined: Fri Jul 19, 2019 12:34 am
Organization: self
Location: Germany

Load Calculation Tool for OC4 on SIMPACK

Postby John.Chang » Tue Jul 23, 2019 6:37 am

Dear senior engieers,

I am trying to model a Load Calculation Tool (LCT) for OC4 semisubmersible floating system on Simpack.
The goal of the simulation is to calculate the fatigue load (DLC 1.2) of the wind turbine.

With the reference of SIMPACK help site, i was able to go through the LCT on ON-Shore WInd turbine.
I am having a hard to time to figure out a way, how to implement the floating base, mooring system, and HydroDyn to the existing work.

I would sincerely appreciate, if you could give a guidance or reference.

Thank you

Jason.Jonkman
Posts: 4277
Joined: Thu Nov 03, 2005 4:38 pm
Location: Boulder, CO
Contact:

Re: Load Calculation Tool for OC4 on SIMPACK

Postby Jason.Jonkman » Tue Jul 23, 2019 8:50 am

Dear John,

I would reach out to SIMPACK technical support for help. I doubt anyone there follows this forum in detail.

Best regards,
Jason Jonkman, Ph.D.
Senior Engineer | National Wind Technology Center (NWTC)

National Renewable Energy Laboratory (NREL)
15013 Denver West Parkway | Golden, CO 80401
+1 (303) 384 – 7026 | Fax: +1 (303) 384 – 6901
nwtc.nrel.gov


Return to “Structural Analysis”

Who is online

Users browsing this forum: No registered users and 0 guests