I am using VS 2017 for coding OpenFast. Every time i place a break point to compile the program, the program continue without stopping at that breakpoint. There is a message appears next to the breakpoint as follows "The breakpoint will not currently be hit. No symbols have been loaded for this document".
Is there any solution for that?
Debugger problem "The breakpoint will not currently be hit. No symbols have been loaded for this document
Moderators: Bonnie.Jonkman, Jason.Jonkman
-
- Posts: 27
- Joined: Mon Dec 25, 2017 5:47 am
- Organization: Zagazig University
- Location: Egypt
-
- Posts: 5428
- Joined: Thu Nov 03, 2005 4:38 pm
- Location: Boulder, CO
- Contact:
Re: Debugger problem "The breakpoint will not currently be hit. No symbols have been loaded for this document
Dear Mohamed,
You should select and use a Debug version (instead of a Release) version if you want to use breakpoints.
Best regards,
You should select and use a Debug version (instead of a Release) version if you want to use breakpoints.
Best regards,
Jason Jonkman, Ph.D.
Senior Engineer | National Wind Technology Center (NWTC)
National Renewable Energy Laboratory (NREL)
15013 Denver West Parkway | Golden, CO 80401
+1 (303) 384 – 7026 | Fax: +1 (303) 384 – 6901
nwtc.nrel.gov
Senior Engineer | National Wind Technology Center (NWTC)
National Renewable Energy Laboratory (NREL)
15013 Denver West Parkway | Golden, CO 80401
+1 (303) 384 – 7026 | Fax: +1 (303) 384 – 6901
nwtc.nrel.gov
-
- Posts: 27
- Joined: Mon Dec 25, 2017 5:47 am
- Organization: Zagazig University
- Location: Egypt
Re: Debugger problem "The breakpoint will not currently be hit. No symbols have been loaded for this document
Thank you for considerations
Return to “Computer-Aided Engineering Software Tools”
Who is online
Users browsing this forum: No registered users and 1 guest