Making fault

Discuss acquisition, use, and manipulation of airfoil data.

Moderator: Bonnie.Jonkman

Jason.Jonkman
Posts: 4338
Joined: Thu Nov 03, 2005 4:38 pm
Location: Boulder, CO
Contact:

Re: Making fault

Postby Jason.Jonkman » Thu Sep 26, 2019 6:49 am

Dear Sebastian,

I would recommend compiling in debug mode and stepping through the solution within VS by adding breakpoints, clicking on Step Into, etc. I'm sure you can find information on how to do this in VS help. You could also post specific questions on OpenFAST issues, where more of the OpenFAST developers are active than in this forum, which tends to cater more towards usage of FAST / OpenFAST.

Best regards,
Jason Jonkman, Ph.D.
Senior Engineer | National Wind Technology Center (NWTC)

National Renewable Energy Laboratory (NREL)
15013 Denver West Parkway | Golden, CO 80401
+1 (303) 384 – 7026 | Fax: +1 (303) 384 – 6901
nwtc.nrel.gov

Jason.Jonkman
Posts: 4338
Joined: Thu Nov 03, 2005 4:38 pm
Location: Boulder, CO
Contact:

Re: Making fault

Postby Jason.Jonkman » Tue Oct 01, 2019 9:39 am

For others following this forum thread, the discussion around Sebestian's code changes has moved from here to OpenFAST issues: https://github.com/OpenFAST/openfast/issues/339.

Best regards,
Jason Jonkman, Ph.D.
Senior Engineer | National Wind Technology Center (NWTC)

National Renewable Energy Laboratory (NREL)
15013 Denver West Parkway | Golden, CO 80401
+1 (303) 384 – 7026 | Fax: +1 (303) 384 – 6901
nwtc.nrel.gov


Return to “Airfoils”

Who is online

Users browsing this forum: No registered users and 0 guests