Hydrodyn Forces

Discuss theory and modeling of wind-turbine structures.

Moderator: Bonnie.Jonkman

Posts: 1
Joined: Thu Jul 11, 2019 5:55 am
Organization: UPC
Location: Spain

Hydrodyn Forces

Postby Andres.Piedra » Tue Mar 03, 2020 9:23 am

Hello everyone,

I am new to FAST, and i'm trying to get all the hydrodynamic forces calculated in FAST, and compared them with the tower base reaction (TwrBsFxt) because I assume that to achieve static equilibrium these forces most be equal.

So I obtained the hydrodynamic forces distributed in each member, transformed them in point loads, sum them and compare them with the resulting hydrodynamic forces calculated by hydrodyn (HydroFxi), and the results were quite similar.

Finally I add all the acting forces in X (hydrodynamics, inertial (-M * PtfmAxT) and moorings), and compared them with the Tower base reaction(TwrBsFxt) and got the next graphic:

The broken line is the tower base reaction, and the other one is the resultant of all my acting forces.

Can someone help me and tell me where my mistake is or if I need to consider another force?

Sorry If my english is not very good i hope you can understand what i'm asking.
Thank you,


Posts: 5872
Joined: Thu Nov 03, 2005 4:38 pm
Location: Boulder, CO

Re: Hydrodyn Forces

Postby Jason.Jonkman » Tue Mar 03, 2020 12:27 pm

Dear Andres,

If I understand correctly, you are trying to compare the tower-reaction loads found by-processing the hydrodynamic applied loads, mooring applied loads, and platform acceleration with the tower-base reaction loads output directly. In general, I would agree that F = m*a for the platform, where F includes applied loads from the tower, hydrodynamics, moorings, as well as the weight of the platform itself, and m*a is the inertia of the platform. The challenge is likely ensuring that all terms are in the same coordinate system--at the platform / tower base, some terms are in the inertial-frame coordinate system (i) and some are in the platform / tower-base coordinate system (t), which orients with the platform as it rotates in roll, pitch, and yaw.

Best regards,
Jason Jonkman, Ph.D.
Senior Engineer | National Wind Technology Center (NWTC)

National Renewable Energy Laboratory (NREL)
15013 Denver West Parkway | Golden, CO 80401
+1 (303) 384 – 7026 | Fax: +1 (303) 384 – 6901

Return to “Structural Analysis”

Who is online

Users browsing this forum: No registered users and 1 guest