Input for airfoilprep excel sheet

Discuss acquisition, use, and manipulation of airfoil data.

Moderator: Bonnie.Jonkman

Danielle.Everett
Posts: 1
Joined: Thu Mar 04, 2021 10:24 am
Organization: self
Location: England

Input for airfoilprep excel sheet

Postby Danielle.Everett » Fri Mar 05, 2021 5:03 am

Hi, I am working on a student project and hoped to use the SWRDC CODE which uses the airfoilprep excel sheet for lift and drag data. I am struggling to understand the input I need and what the x and y values are in the "interpolate" sheet. I just want the lift and drag data for a naca 6409.

Jason.Jonkman
Posts: 5729
Joined: Thu Nov 03, 2005 4:38 pm
Location: Boulder, CO
Contact:

Re: Input for airfoilprep excel sheet

Postby Jason.Jonkman » Fri Mar 05, 2021 6:49 am

Dear Danielle,

The X and Y values in the Interpolate worksheet of AirfoilPrep are typically the angle of attack (X) and lift coefficient or drag coefficient (Y). But this Worksheet is only need if you need to switch from one set of angles of attack to another.

Best regards,
Jason Jonkman, Ph.D.
Senior Engineer | National Wind Technology Center (NWTC)

National Renewable Energy Laboratory (NREL)
15013 Denver West Parkway | Golden, CO 80401
+1 (303) 384 – 7026 | Fax: +1 (303) 384 – 6901
nwtc.nrel.gov


Return to “Airfoils”

Who is online

Users browsing this forum: No registered users and 1 guest