Dear Jason,
I have plotted power-rotor speed for 10 kW wind turbine under 8m/s, 9 m/s, 10 m/s and 11.5 m/s wind speeds. The rated wind speed for this turbine is 11.5 m/s in which the power should reach maximum 10kW but in the figure it is less than 10 kW. Generator efficiency and gearbox efficiency is 100%.
The power is obtained through RtAeroPwr in Aerodyn.
Please let me know what could be the problem?
Kind regards,
Babak
10kW wind turbine power curve
Moderators: Bonnie.Jonkman, Jason.Jonkman
-
- Posts: 29
- Joined: Sat Mar 14, 2020 12:03 pm
- Organization: ---
- Location: Belgium
10kW wind turbine power curve
- Attachments
-
- power-speed.JPG (34.09 KiB) Viewed 379 times
-
- Posts: 5428
- Joined: Thu Nov 03, 2005 4:38 pm
- Location: Boulder, CO
- Contact:
Re: 10kW wind turbine power curve
Dear Babak,
When you say:
are you referring to a report, measured data, or simulation results?
Are you confident that the turbine is being modeled in a way that would give the power curve you are expecting?
Best regards,
When you say:
the rated wind speed for this turbine is 11.5 m/s in which the power should reach maximum 10kW
are you referring to a report, measured data, or simulation results?
Are you confident that the turbine is being modeled in a way that would give the power curve you are expecting?
Best regards,
Jason Jonkman, Ph.D.
Senior Engineer | National Wind Technology Center (NWTC)
National Renewable Energy Laboratory (NREL)
15013 Denver West Parkway | Golden, CO 80401
+1 (303) 384 – 7026 | Fax: +1 (303) 384 – 6901
nwtc.nrel.gov
Senior Engineer | National Wind Technology Center (NWTC)
National Renewable Energy Laboratory (NREL)
15013 Denver West Parkway | Golden, CO 80401
+1 (303) 384 – 7026 | Fax: +1 (303) 384 – 6901
nwtc.nrel.gov
Return to “Computer-Aided Engineering Software Tools”
Who is online
Users browsing this forum: Feng.Qian and 1 guest