Compiling NAFNoise

Provide feedback, request enhancements, and get help with wind-turbine computer-aided engineering tools.

Moderators: Bonnie.Jonkman, Jason.Jonkman

Posts: 4
Joined: Thu May 30, 2013 3:40 am
Organization: DTU
Location: Denmark

Compiling NAFNoise

Postby Arash.Mohammady » Wed Jun 26, 2019 6:17 am

Dear all,

I did some modification on NAFnoise source code but I am running into troubles when I try to compile it.
I tried to compile it using both Intel fortran compiler and Gfortran (using NETBeans).
I have attached 2 snapshots of error that I get in both Gfortran and Intel compiler.

I would appreciate it very much if you could guide me how to compile the code.


Best regards,

IntelCompiler_error.PNG (74.69 KiB) Viewed 896 times

gfortran_error.PNG (17.65 KiB) Viewed 896 times

Posts: 5428
Joined: Thu Nov 03, 2005 4:38 pm
Location: Boulder, CO

Re: Compiling NAFNoise

Postby Jason.Jonkman » Wed Jun 26, 2019 8:24 am

Dear Arash,

I'm not sure; I've never used NAFnoise before.

DFPORT is a system-specific module that is in the old (discontinued) Compaq compiler. Changes will be needed to compile with Intel Fortran or gfotran e.g. DFPORT to IFPORT, but there are likely other changes that are needed.

Best regards,
Jason Jonkman, Ph.D.
Senior Engineer | National Wind Technology Center (NWTC)

National Renewable Energy Laboratory (NREL)
15013 Denver West Parkway | Golden, CO 80401
+1 (303) 384 – 7026 | Fax: +1 (303) 384 – 6901

Return to “Computer-Aided Engineering Software Tools”

Who is online

Users browsing this forum: No registered users and 1 guest