Surface visualization of DTU-10 MW

Provide feedback, request enhancements, and get help with wind-turbine computer-aided engineering tools.

Moderators: Bonnie.Jonkman, Jason.Jonkman

Ghaith.Esber
Posts: 2
Joined: Mon Jun 17, 2019 7:12 am
Organization: Rostock university
Location: Deutschland

Surface visualization of DTU-10 MW

Postby Ghaith.Esber » Tue Jun 18, 2019 7:42 am

Dear All,
I would like to visualize my openFAST-v1.0.0 simulations of the DTU-10 MW mounted on a spar-buoy.
My simulations ran very well and I was able to visualize them with "basic meshes" or "all meshes". However, when I try to visualize using surfaces, the simulation abort and I get an error message.
Attached is a screenshot of the error.
I highly appreciate any information regarding the source of this error.

kind regards
Ghaith Esber
Attachments
Error.jpg
Error.jpg (168.25 KiB) Viewed 489 times

Jason.Jonkman
Posts: 4223
Joined: Thu Nov 03, 2005 4:38 pm
Location: Boulder, CO
Contact:

Re: Surface visualization of DTU-10 MW

Postby Jason.Jonkman » Tue Jun 18, 2019 12:28 pm

Dear Ghaith,

This issue was fixed in December, 2018 with the following pull request into OpenFAST dev: https://github.com/OpenFAST/openfast/pull/212, which has now been released in OpenFAST v2.1.

Best regards,
Jason Jonkman, Ph.D.
Senior Engineer | National Wind Technology Center (NWTC)

National Renewable Energy Laboratory (NREL)
15013 Denver West Parkway | Golden, CO 80401
+1 (303) 384 – 7026 | Fax: +1 (303) 384 – 6901
nwtc.nrel.gov

Ghaith.Esber
Posts: 2
Joined: Mon Jun 17, 2019 7:12 am
Organization: Rostock university
Location: Deutschland

Re: Surface visualization of DTU-10 MW

Postby Ghaith.Esber » Wed Jun 19, 2019 1:56 am

Dear Jason,
Thank you very much for your reply. it was a great help!

Best regards,


Return to “Computer-Aided Engineering Software Tools”

Who is online

Users browsing this forum: No registered users and 1 guest