Page 1 of 1

Debugger problem "The breakpoint will not currently be hit. No symbols have been loaded for this document

Posted: Sun Jun 09, 2019 2:09 am
by Mohamed.Fekry
I am using VS 2017 for coding OpenFast. Every time i place a break point to compile the program, the program continue without stopping at that breakpoint. There is a message appears next to the breakpoint as follows "The breakpoint will not currently be hit. No symbols have been loaded for this document".
Is there any solution for that?
Debug.png
Debug.png (153.75 KiB) Viewed 632 times

Re: Debugger problem "The breakpoint will not currently be hit. No symbols have been loaded for this document

Posted: Sun Jun 09, 2019 1:55 pm
by Jason.Jonkman
Dear Mohamed,

You should select and use a Debug version (instead of a Release) version if you want to use breakpoints.

Best regards,

Re: Debugger problem "The breakpoint will not currently be hit. No symbols have been loaded for this document

Posted: Sun Jun 09, 2019 8:25 pm
by Mohamed.Fekry
Thank you for considerations