About calculating the tower base load

Provide feedback, request enhancements, and get help with wind-turbine computer-aided engineering tools.

Moderators: Bonnie.Jonkman, Jason.Jonkman

Xing.Wei
Posts: 68
Joined: Mon Jul 18, 2016 1:42 pm
Organization: University of Warwick
Location: University of Warwick, Coventry,UK

About calculating the tower base load

Postby Xing.Wei » Wed Nov 14, 2018 8:39 am

Dear All

I am simulating an offshore wind turbine using the FAST 8. I designed a controller to control the platform pitch angle. I am wondering what the values should I use to compare the performance of the controller.

1. I calculate the root-mean-square of the pitch angle with the 0 degree as the mean value.
2. I calculate the standard deviations of the pitch angles with the mean pitch angle calculated by available data.

As for the tower base fatigue load, I am wondering if the value obtained from situation 1 is more suitable to describe the tower base load or the value obtained from situation 2? I know I can calculate the tower base load using MLife. I am just wondering if the situation 1 is more meaningful or situation 2 in terms comparing the tower base load.

Best

XING WEI

Jason.Jonkman
Posts: 4614
Joined: Thu Nov 03, 2005 4:38 pm
Location: Boulder, CO
Contact:

Re: About calculating the tower base load

Postby Jason.Jonkman » Wed Nov 14, 2018 11:21 am

Dear Xing.Wei,

The root-mean-square with zero mean and the standard deviation about the mean are both approximations of what is more commonly used to assess fatigue i.e. the damage-equivalent load (DEL). In MLife, the effect of the nonzero mean can be accounted for in the calculation of the DEL, using the Goodman correction.

Please note that assessing the performance of a controller is rarely straightforward, as it is not typically suitable to focus on only one load metric. In addition to the tower-base load, it is likely also important to assess blade loads, drivetrain loads, tower-top loads, tower-top accelerations, actuator duty cycle, power output, etc.

Best regards,
Jason Jonkman, Ph.D.
Senior Engineer | National Wind Technology Center (NWTC)

National Renewable Energy Laboratory (NREL)
15013 Denver West Parkway | Golden, CO 80401
+1 (303) 384 – 7026 | Fax: +1 (303) 384 – 6901
nwtc.nrel.gov


Return to “Computer-Aided Engineering Software Tools”

Who is online

Users browsing this forum: No registered users and 1 guest