Page 1 of 1

yielding analysis

Posted: Thu Mar 16, 2017 8:34 am
by Purushotham.Chinu
Dear jason,

I paln to carry out the fatigue yielding analysis of the test23 case , so my approach is as follows the tension divided by the tether area would give me the associated stresses in the tethers across time now i want to look at the number of times the stress level exceeds the given value of yield stress of the material over a given length of simulation time would give me the number of cycles, from where can i get the tether diameter in the fast files,


regards

Re: yielding analysis

Posted: Thu Mar 16, 2017 11:15 am
by Jason.Jonkman
Dear Purushotham,

If you haven't changed Test23 in anyway, the mooring parameters are defined in the FEAMooring input file, but as it turns out, the tendon/line diameter is not actually specified in this file. Regardless, the effective tendon/line diameter for the MIT/NREL TLP is 0.127 m.

Best regards,