yielding analysis

Provide feedback, request enhancements, and get help with wind-turbine computer-aided engineering tools.

Moderators: Bonnie.Jonkman, Jason.Jonkman

Purushotham.Chinu
Posts: 39
Joined: Tue Feb 21, 2017 7:37 am
Organization: IITM
Location: India

yielding analysis

Postby Purushotham.Chinu » Thu Mar 16, 2017 8:34 am

Dear jason,

I paln to carry out the fatigue yielding analysis of the test23 case , so my approach is as follows the tension divided by the tether area would give me the associated stresses in the tethers across time now i want to look at the number of times the stress level exceeds the given value of yield stress of the material over a given length of simulation time would give me the number of cycles, from where can i get the tether diameter in the fast files,


regards

Jason.Jonkman
Posts: 5872
Joined: Thu Nov 03, 2005 4:38 pm
Location: Boulder, CO
Contact:

Re: yielding analysis

Postby Jason.Jonkman » Thu Mar 16, 2017 11:15 am

Dear Purushotham,

If you haven't changed Test23 in anyway, the mooring parameters are defined in the FEAMooring input file, but as it turns out, the tendon/line diameter is not actually specified in this file. Regardless, the effective tendon/line diameter for the MIT/NREL TLP is 0.127 m.

Best regards,
Jason Jonkman, Ph.D.
Senior Engineer | National Wind Technology Center (NWTC)

National Renewable Energy Laboratory (NREL)
15013 Denver West Parkway | Golden, CO 80401
+1 (303) 384 – 7026 | Fax: +1 (303) 384 – 6901
nwtc.nrel.gov


Return to “Computer-Aided Engineering Software Tools”

Who is online

Users browsing this forum: No registered users and 1 guest