## TurbSim CPU Times

Provide feedback, request enhancements, and get help with wind-turbine computer-aided engineering tools.

Moderators: Bonnie.Jonkman, Jason.Jonkman

Bonnie.Jonkman
Posts: 575
Joined: Thu Nov 10, 2005 10:51 am
Organization: Envision Energy USA
Location: Colorado
Location: Boulder, CO
Contact:

### TurbSim CPU Times

I occasionally get questions regarding the approximate time that it takes to create large grids in TurbSim, so I thought I would post some plots to illustrate the relationship between the number of grid points (on an n by n grid) and computation time. The computation time is dominated by the Cholesky decomposition of an n^2 by n^2 matrix at each time step.

These plots were created using the IECKAI model with TurbSim v1.50 (non-IEC models can take at least 2 times longer because they compute a Cholesky decomposition on the v- and w- wind components as well). I used AnalysisTime = 600 seconds and TimeStep = 0.05 seconds, and I ran this on a 32-bit WinXP Duo Core CPU (2.83 GHz) with 4 GB RAM. For each simulation, I used the same input file, changing only NumGrid_z and NumGrid_y (which are equal in each case), and plotted the CPU time listed at the end of the simulation.

Here are the results, plotted in two different ways:
TurbSim_Timing_1.PNG (12.77 KiB) Viewed 19626 times

TurbSim_Timing_2.PNG (16.34 KiB) Viewed 19626 times

The 41 x 41 grid required a little less than 0.5 GB RAM, so all of these cases ran well within memory.

NOTE: I used a 10 m/s mean hub-height wind speed and 140 m x 140 m grids for these simulations. Interestingly, when I ran the 17 x 17 case using 12.368 m/s and a 50 m x 50 m grid instead (everything else was the same), the CPU time increased from approximately 39 s to 94 s. This is due to the fact that the coherence matrix is more difficult to factor. Keep this in mind when comparing specific CPU times with these plots.
Bonnie Jonkman

Envision Energy USA, 2016-
National Renewable Energy Laboratory, 2003-2016

Return to “Computer-Aided Engineering Software Tools”

### Who is online

Users browsing this forum: No registered users and 1 guest