Can anybody help me with the design of PI-IPC?

This forum if for discussing controls. Questions about how to implement controls in FAST are more appropriate to the CAE Tools forum.

Moderator: Bonnie.Jonkman

Yanhua.Liu
Posts: 34
Joined: Mon Feb 29, 2016 5:22 am
Organization: University of Hull
Location: HULL,UK

Can anybody help me with the design of PI-IPC?

Postby Yanhua.Liu » Mon Sep 19, 2016 5:18 am

Hi all,

I am doing some research about Individual Pitch Control (IPC). Now I am trying to design an IPC system based Proportional-integral (PI) method and validated on the FAST software. I am using NREL 5MW wind turbine with baseline generator torque and pitch controller. My design is shown as the attachment.
IPC design.jpg
IPC design.jpg (19.87 KiB) Viewed 6230 times


Before the Coleman transformation, the flapwise bending moments are filtered with a notch filter tuned to the 1P frequency and scaled. After the reverse transformation, the signals are filtered again by a low-pass filter to obtain smooth control signals. According to the above design, the parameters of the I controllers has been tuned to the best. However, the performance of IPC controllers is not good. The magnitude of the flapwise blending moment of blade 1 is barely reduced.

Is there anything wrong with my IPC design? Can you help me with the possible faults and possible improvement methods?  Thanks a lot.

Yanhua

Return to “Controls”

Who is online

Users browsing this forum: No registered users and 1 guest