Banded white noise simulation

Topics of general, but wind-related interest.

Moderator: Bonnie.Jonkman

Tomas.Cortes
Posts: 29
Joined: Fri Mar 15, 2019 7:18 am
Organization: Mr
Location: Portugal

Banded white noise simulation

Postby Tomas.Cortes » Wed Jun 26, 2019 6:44 am

Hi everybody,

Does anyone know how to set up the load case 2.6 in hydrodyn file? I see where I can set the white noise option (WaveMod) but not the frequency range and the PSD specified...

Thanks in advance,

Tomás

Jason.Jonkman
Posts: 5082
Joined: Thu Nov 03, 2005 4:38 pm
Location: Boulder, CO
Contact:

Re: Banded white noise simulation

Postby Jason.Jonkman » Wed Jun 26, 2019 8:12 am

Dear Tomas,

Select WaveMod = 3 to enable a white-noise spectrum. The lower and upper cut-off frequencies are set via WvLowCOff and WvHiCOff. The magnitude of the PSD within this frequency range is determined by WaveHs.

Best regards,
Jason Jonkman, Ph.D.
Senior Engineer | National Wind Technology Center (NWTC)

National Renewable Energy Laboratory (NREL)
15013 Denver West Parkway | Golden, CO 80401
+1 (303) 384 – 7026 | Fax: +1 (303) 384 – 6901
nwtc.nrel.gov


Return to “General”

Who is online

Users browsing this forum: No registered users and 1 guest