Simulation error: UJacScl

Topics of general, but wind-related interest.

Moderator: Bonnie.Jonkman

Aananthy.Sarma
Posts: 2
Joined: Wed Aug 01, 2018 4:17 am
Organization: Loughborough University
Location: United Kingdom

Simulation error: UJacScl

Postby Aananthy.Sarma » Fri Aug 03, 2018 3:57 am

Hi there,

I'm trying to run FASTV8 for a model turbine. The parameters and flags in the aerodyn, elastodyn files have been set to match the model turbine (appropriate scaling is included) and I keep getting this "error occurred while trying to read UJacSclFact." I'm not sure why this is happening. Could you kindly help me out?

Thanks!

Aananthy Sarma

Jason.Jonkman
Posts: 5057
Joined: Thu Nov 03, 2005 4:38 pm
Location: Boulder, CO
Contact:

Re: Simulation error: UJacScl

Postby Jason.Jonkman » Fri Aug 03, 2018 6:46 am

Dear Aananthy,

My guess is your FAST primary input file is formatted improperly. As with any input file format problem, I suggest that you use the Echo option from the primary FAST input file to debug errors in the input-file processing.

Best regards,
Jason Jonkman, Ph.D.
Senior Engineer | National Wind Technology Center (NWTC)

National Renewable Energy Laboratory (NREL)
15013 Denver West Parkway | Golden, CO 80401
+1 (303) 384 – 7026 | Fax: +1 (303) 384 – 6901
nwtc.nrel.gov


Return to “General”

Who is online

Users browsing this forum: No registered users and 1 guest